Hello there all, I am new to the forum so please excuse my weak knowledge & if i am on the wrong site or place please tell me.
I was wondering if possibly anyone could help me as you all seem knowledgeable chaps from reading .
I am currently a student and I have been given a task to design & manufacture a vibration isolation table.
I wondered if anyone has any past experience with these and could give me some help possibly?
The vibration table has to be good enough to use surface mapping equipment on it.
My knowledge is very basic and any design ideas or anything that would be of use will be greatly appreciated.
Thank you for reading, hope you are not all too bored with my problem.
Kindest Regards
Thomas Snaylam
FD - Computer Aided Design at UCLAN University
I was wondering if possibly anyone could help me as you all seem knowledgeable chaps from reading .
I am currently a student and I have been given a task to design & manufacture a vibration isolation table.
I wondered if anyone has any past experience with these and could give me some help possibly?
The vibration table has to be good enough to use surface mapping equipment on it.
My knowledge is very basic and any design ideas or anything that would be of use will be greatly appreciated.
Thank you for reading, hope you are not all too bored with my problem.
Kindest Regards
Thomas Snaylam
FD - Computer Aided Design at UCLAN University