I have spoken to him , nice guy and seems well versed it the devices and give full support . For me I need a four way and it will cost about 8 k . And as that is not a lot given this hobby. But I would like to here some successful stories before I go through with this. As for this system it is the most complete as it does come with all features so in this way it's really the only choice I could find. The only choice that comes close is the accuphase df55. And IRS 20 k and does not do room correction through software. So as I do not seem to have many choices , I am just looking to here some Ra RA for the equipment .
And thanks for replying
How does it fit into your system given the analogue source(s) and pre-amp? Are you feeding it with the pre-amp output? Or as an input to the pre-amp for digital sources? If it's the former then is resolution maintained at low volumes?
How does it fit into your system given the analogue source(s) and pre-amp? Are you feeding it with the pre-amp output? Or as an input to the pre-amp for digital sources? If it's the former then is resolution maintained at low volumes?
I use it in the tape loop. This way maximum resolution is maintained and I use my pre amp as normal.
I must admit I was quite surprised when deqx told me that digital resolution is so poor on low level/low volume.
I can listen without eq, deqx in the loop with speaker calibration and 3 eq presets all at the press of the remote.
Hard to believe ( it took me a while to remove my audiophile prejudices), but even an analog lover can enjoy transparent dsp eq.