I have MTU at 9216
Jumboframes disabled
Flowcontrol disabled (both RX & TX)
802.1x disabled
Keepalive disabled on all ports
Spanning tree at RSTP with priority at 32768
Vlan enabled, set to untagged
Switch port modes routing disabled, switching enabled, security disabled
IPv6 disabled
I do have thread detection partially enabled
This may not give you the best results since this is a busy network. However a high rate video stream does not impact SQ.
thank you Emile.
I must say we Have to have better Routers .
example
maximum value of MTU in edgerouterX is 2008, defult value is 1500.
Emile has MTU at 9216 !
I found this as one of the most important values in network .
Values lower than 1000 are very thin sounding , values at 2000 much better balanced,
I wish I had MTU at 9216 , but the edgerouter X is not supporting the values higher than 2008.
it is the same story like with the low power servers. They play but are far from ideal.
Router is no difference. It needs a lot of calculating power, especially with firewall and vlan !
vlan can lower the real speeds to 4 times less !
interesting is that the security is didabled at Emile router, I understand Firewall is active ?
will try to test some things during the weekend days .