Apogee diva setup

[Alrainbow]

This album is done very well I think and has many players to help pick out sounds
I’ve used this as an example

 

[christoph]

3 ohm was the official specs from Apogee , its the only model i never had a chance to measure so cant confirm it .. BTW You must have them in a small room for such low power to work ..!

They are defo 6 Ohms and the room they are in now is around 48 m2.

 

[Alrainbow]

In fact tomorrow ill
Post pics of stats from software
I use Dayton stuff it’s not Uber expensive but does more then enough
I’ve measured them and did tests using software and mic
The lowest is the tweeter next the mid
then the woofer will panel
now this is direct from each driver
If you go through the cross over it’s much higher and much closer to Chris posts
my room is not large
9 foot high
17 feet deep and 15 feet wide
Speakers are setup on the short side

 

[Alrainbow]

Room not done but enough to play music
Amps in room behind the front wall.
48 from front wall to back of apps
70 inches tweet to tweet.
This is a basic starting point
Image is very solid it’s tone that I keep working on
seat makes stage change 6 to 8 feet they are here and love that but stage is not wall to wall
9 to 11 feet I am there and stage is about width of the room.
for now walls are plain no treatments at all.

 

[Alrainbow]

Room not done but enough for music

 

[christoph]

Room not done but enough for music View attachment 154951

Hi Al
I would even place them bang to the sidewall in your narrow room and try to pull them out into the room as far as possible.

 

[Alrainbow]

I can’t say I did that yet but I will try this tomorrow