Show us your cable management system

[hongkongfoufou]

You would connect the qkore to either a dedicated ground post or one of the chassis screws.

Thanks

 

[joaovieira]

Very interesting solution from Solid Tech.

 

[andromedaaudio]

Okay here we go the secret sauce revealed.
A nice audiophile power cable to the corner but oeps dont look behind the absorber

 

[andromedaaudio]

The red and white speaker cable are layed out in a special S pattern to balance out the electron flow lol

 

[andromedaaudio]

Okay i agree the 4 euro white plastic one looked awful .
I purchased a beautifull brennenstuhl with alu housing for 18 euros made in Germany

Ps i cant hear any difference

 

[Josaa]

I have a idiot question : how do you connect your amplifier?
I find this information :

Do NOT connect banana/spade terminations to speaker outputs.
This could result in a short circuit to your amplifier. Only connect
banana/spade ends of your QKORE Wire to your QBASE or QKORE.

My first idea is to connect QKORE Wire between spade amplifier output to the banana Qkore6.
It seems it is a bad idea.

Thanks

Connect to ground post or signal connector (rca/xlr/bnc/etc), except primary earth that is for qbase. There are plenty of different qcore wires.

 

[Ola Swede]

Hi there...
New in this forum, Googled for cable elevators and ended up here .
For now I'm using a cheap solution for getting the cables of the floor, I think it looks nicer and have no clue if there is any approvement on the sound.
They are made of rubber and used to stiffen up old springs on the shock absorbers on a car

 

[john2020]

Cable Lifters from HIFISTAY ~