Recent content by kayhikski
-
K
Shunyata Grounding System
Testing now with a Signal Hub and a bunch of Alpha cables on loan from thecableco.com. The thing that had me confused with the naming is that I was thinking that chassis connections belong on a chassis hub and a signal hub is only for signal connections. Not true. Richard told me that a...- kayhikski
- Post #271
- Forum: Shunyata Research Cable Forum
-
K
Shunyata Grounding System
Hi, Yes I re-read the Hub Selection Guide and you are right. Seems like if you start with a Chassis Hub and want to segment digital and analog later on, then leaving the analog components on the Chassis Hub and adding a Signal Hub for the digital components works pretty well too. I’ll do some...- kayhikski
- Post #269
- Forum: Shunyata Research Cable Forum
-
K
Shunyata Grounding System
Hi there - thanks very much, My plan is to start with my preamp, analog crossover and monoblock amps on a chassis hub and then to potentially add in digital components with a signal ground hub.- kayhikski
- Post #267
- Forum: Shunyata Research Cable Forum
-
K
Shunyata Grounding System
Thanks very much. I am unable to get a low Ohm reading from anywhere on my KTE May to the Ground Pin on the IEC receptacle . I had no issues with all my other gear .. S/PDIF on my Holo Audio Red was sub 1 Ohm and for most other gear I can use a chassis screw, which I think is preferred in any...- kayhikski
- Post #265
- Forum: Shunyata Research Cable Forum
-
K
Shunyata Grounding System
Hello there, just looking at potentially adding an Altaira to my setup (already have Venom CGS from my EtherREGEN to my Denali 6000s v2. QN - I have a Holo Audio May KTE but I can't seem to get a low resistance reading anywhere. Do you get <1 Ohm to the S/PDIF? Thanks, James- kayhikski
- Post #263
- Forum: Shunyata Research Cable Forum
 | Steve Williams Site Founder | Site Owner | Administrator |  | Ron Resnick Site Co-Owner | Administrator |  | Julian (The Fixer) Website Build | Marketing Managersing |