Hi everyone
Hi people,
After reading a series of postings on STUDER yahoo group I checked the battery on my MP board. Battery was down to 0.6V and ready to "pop" (very green around). Also I was getting EEE01 error message. I replaced it with one from e-bay.
Does anyone have a clear procedure for realignment of the machine after replacement of the battery? Where can I find decent calibration tapes for STUDER A810? Can settings be taken from another machine via tape and read in?
I am pretty new to STUDER A810, I have a service manual in original but when I read the alignment procedure sounded pretty complicated. I don't think you have to realign the heads just because you replaced the battery!
Your help is much appreciated.
Best regards from down under,
EUGEN
Hi people,
After reading a series of postings on STUDER yahoo group I checked the battery on my MP board. Battery was down to 0.6V and ready to "pop" (very green around). Also I was getting EEE01 error message. I replaced it with one from e-bay.
Does anyone have a clear procedure for realignment of the machine after replacement of the battery? Where can I find decent calibration tapes for STUDER A810? Can settings be taken from another machine via tape and read in?
I am pretty new to STUDER A810, I have a service manual in original but when I read the alignment procedure sounded pretty complicated. I don't think you have to realign the heads just because you replaced the battery!
Your help is much appreciated.
Best regards from down under,
EUGEN