The photo on the Doshi website does not show the decimal point, so there must be some change to the display on the newest v3 units.
Now you, like myself, are confused about how to interpret the display.
From the website:
With MC cartridges, loading can be varied from 10 to 250 Ohms in 10 Ohm steps and from 250 to 6K Ohms in 20 Ohm steps. Two loading options can be stored and toggled to allow instantaneous comparison, thereby facilitating fine-tuning of any MC cartridge. Two MM inputs—47 kOhms and 10 kOhms—are also provided.
I did cycle through the inputs, and remember seeing the 47 but don't recall the location of the decimal point. I am going to take a few pictures of the range of values on the display, see if anything can be interpreted, including looking to see where (if) the values change how much they increment. It will at least give an idea of where 250 Ohms is.